Bimini-Top Jolly for roll bar GOMMONE
The Bimini Top JOLLY is handy and sturdy and thanks to its telescopic AISI 316 stainless steel structure, easy to be closed with spring buttons. Suggested for the installation on stainless steel shaped roll bars (like our model GOMMONE) of RIBs. The roll bar is not included in the scope of delivery!
Note: The sizes given refer to the installation width at the lower edge of the roll bar from the center of the base plate to the center of the base plate.
Dismountable telescopic structure (Ø 25/20 mm) made from AISI 316 polished stainless steel tubes.
The sunroof material is the AIRTEX® fabric from Mehler Texnologies, it is weatherproof and UV-resistant, antimicrobial, as well as dirt and water-repellent. The fabric complies with the UNI EN 24920 standard and is available in 14 different colours. This 200 g/m² light fabric is a 100% polyester fabric that is acrylate-coated and impregnated on one side. The special coating gives the material a distinctive textile character. With a total weight of only 200 g/sqm, this quality achieves a very good sun protection effect according to UV Standard 801.
Joints and screws
All screws and joints are made of AISI 316 stainless steel.
The maximum recommended speed when cruising and the bimini is set up is 15 knots.
The width (D) depends on your width choice of this product.
The length (B) is 205 cm.
NOTE: The available sizes (width) refer to the installation width at the bottom of the roll bar, from the centre of the plate to the centre of the plate.
Scope of delivery
- Velcro closure storage bag (same colour like the bimini)
The starting point
The first measurement to take is the width between the right centre gunwale to the left centre one of the boat or, in case of an inflatable boat, the width between the right centre tubular to the centre left one.
From this size it can be evaluated which model of Bimini Top can be installed.